This tutorial will walk you through how to install and configure TeamViewer on your Raspberry Pi 4.

If help is needed for shell commands then teamviewer -help)Ģ.) After installing TeamViewer please setup the unattended password teamviewer -passwd ģ.) After please stop the daemon with sudo teamviewer -daemon stopĤ.) Write into the nf file located in /opt/teamviewer/config/nf the following lines:ĥ.) Then start the daemon with sudo teamviewer -daemon -start or restart if needed sudo teamviewer -daemon restartĦ.) Then restart GDM with the command systemctl restart gdm.Are you looking for a way to remotely access and control your Raspberry Pi from anywhere in the world? Look no further! Whether you are a seasoned Raspberry Pi user or new to the world of single-board computers, TeamViewer on Raspberry Pi is all you need. Thank you in advance and please let me know if you have any further questions.ġ.) SSH into the machine to install TeamViewer (Follow installation instructions. You can then run TeamViewer with the command sudo teamviewer & disown as it removes the process from the shell's job control, but it still leaves it connected to the terminal. To allow the GUI to be opened and retrieve the TeamViewer ID. There will be a parameter for this coming out in a later release, however, for now please stop the TeamViewer daemon with the following command:Īnd then just add the following lines in the /opt/teamviewer9/config/nfig file:Īfter this please start the TeamViewer daemon with the following command:Īlso, please run the command (in debian based distros)Įxport DISPLAY=:0 nohup iceweasel &>/dev/null & When installing TeamViewer through SSH please keep in mind there is an EULA agreement which must be accepted before the GUI is able to launch to receive an ID. I wrote same question to teamviewer support and got such reply:

Teamviewer command line